Programming (Pendant) Transmitter VLSM

Loading Transmitter(s).

1.  Press and hold the GREEN Power/Reset button until the buzzer sounds the second time (Approximately 5 seconds) then release. The system is now in the “Test” Mode.

2.  Press the RED Emergency button and active a transmitter AT THE SAME TIME. The buzzer will sound indicating the transmitter key code is loaded into memory.

3.  Activate the transmitter a few times to verify the transmitter is loaded and the unit responds. 

4.  Then press the GREEN button to reset the unit.

Information: To add an additional pendant repeat loading transmitter instructions. 

To Erase All Transmitters From Memory.

1.  Press and hold the GREEN Power/Reset button until it buzzes two times (Approximately 15 seconds) and the RED Emergency button starts flashing.

2.  Press and hold the RED Emergency button until it buzzes (Approximately 3 to 5 Seconds).

3.  Then press the GREEN button to reset.